秸秆气发电机组小故障你学会了也可以轻松解决
1、节温器损坏
1. Thermostat damaged
秸秆气发电机组如果出现水温如过高的现象,一般是由于节温器失效的缘故,致使冷却液大循环流速减慢,需要购买新的节温器进行替换。
If the water temperature of the straw gas generator set is too high, it is generally due to the failure of the thermostat, which slows down the circulation flow rate of the coolant. A new thermostat needs to be purchased for replacement.
2、风扇皮带开裂的解决方
2. Solution to cracking of fan belt
秸秆气发电机组的电扇皮带损坏,应立即停机进行替换。假如当下没有条件更行替换,能够将原电扇皮带的断口两头钻两个小孔,再用粗金属丝把断皮带衔接进来做应急运用。需求留意的是,钻孔和断面间应保存恰当的间隔,防止将孔拉裂,金属丝的接头应留在皮带的外侧,皮带不要调的过紧。假如电扇皮带损坏较严峻无法衔接,能够把绳子或布带、牛皮带用铁丝扎紧,编制成一根暂时运用的皮带。格外要留意长短和粗细应与原皮带持平,绳头应当夹在绑好。
The fan belt of the straw gas generator set is damaged and should be stopped immediately for replacement. If there are no conditions to replace it at the moment, two small holes can be drilled at both ends of the original fan belt fracture, and thick metal wire can be used to connect the broken belt for emergency use. It should be noted that appropriate spacing should be maintained between drilling and cross-sections to prevent holes from tearing. The joints of the metal wires should be left on the outside of the belt, and the belt should not be adjusted too tightly. If the fan belt is severely damaged and cannot be connected, it is possible to tie the rope, cloth belt, or cowhide belt with iron wire and weave it into a temporary belt for use. Special attention should be paid to the length and thickness of the belt, which should be level with the original belt, and the rope end should be clamped in the center and tied tightly.
3、散热器水管漏水
3. Radiator water pipe leakage
秸秆气发电机组的使用过程中,散热器水管内部的水温过高,外部的温度过低。或是因为秸秆气秸秆气发电机组组的震荡,很容易造成水箱的水管漏水的现象。秸秆气秸秆气发电机组组的水箱漏水可以把散烟丝放入水箱内,利用水循环的压力,来使烟丝堵塞在散热管的漏水处以便暂时运用。假如水箱散热管漏水状况较严峻,能够把漏水处剪断,再把棉花团涂上番笕者在被剪断的散热管处,再用钳子把被剪断的散热管的头部夹扁,再卷边压紧即可止住漏水状况。
During the use of straw gas generator sets, the water temperature inside the radiator water pipe is too high and the external temperature is too low. Or it may be due to the vibration of the straw gas generator set, which can easily cause water leakage in the water tank pipes. The water tank of the straw gas and straw gas generator unit is leaking. The scattered tobacco can be placed into the water tank, and the pressure of the water circulation can be used to block the tobacco at the leakage point of the heat dissipation pipe for temporary use. If the water leakage situation of the radiator heat pipe is severe, you can cut off the leaking area, then apply soap to the cotton ball at the cut heat pipe, use pliers to flatten the head of the cut heat pipe, and then roll the edge tightly to stop the leakage situation.
4、水泵漏水
4. Water pump leakage
秸秆气发电机组使用铝水泵,有时会出现密封不严的现象。应当把水封平面修磨平坦,或者把水封翻转180°再安装运用。假如止推橡皮圈损坏、胀大变形、绷簧弹力缺乏、折断等,都应当予以替换,并且在安装时牢记不要将绷簧压死。
The straw gas generator set uses an aluminum water pump, which sometimes results in poor sealing. The flat surface of the water seal should be polished flat, or the water seal should be flipped 180 ° before installation and use. If the thrust rubber ring is damaged, swollen or deformed, the tension spring lacks elasticity, breaks, etc., it should be replaced, and remember not to press the tension spring tightly during installation.
感谢您的阅读,此文的文章来源:焦化发电机组更多的内容和问题请点击://www.gz-yanye.com我们会继续努力的为您提供服务,感谢您的支持!
Thank you for reading. The source of this article is: Coking Power Unit. For more information and questions, please click: //www.gz-yanye.com We will continue to work hard to provide you with services. Thank you for your support!