欢迎进入济南济柴环能燃气发电设备有限公司官网!
当前位置:首页 - 新闻中心 - 行业资讯

行业资讯

燃气发电机组千瓦启动和运行注意事项

返回 2022.07.26 来源://www.gz-yanye.com 0
燃气发电机组千瓦起动和运行需要注意哪些事项呢?这不仅是为了保证机组的正常运行,更是为了让工作人员良好使用机组。燃气发电机组千瓦启动和运行注意事项小编做出介绍。
What matters need to be paid attention to when starting and running gas-fired generator units? This is not only to ensure the normal operation of the unit, but also to allow staff to make good use of the unit. The precautions for kW startup and operation of gas-fired generator units are introduced.
一、燃气发电机组千瓦启动的注意事项
1、 Precautions for kW startup of gas generator set
1、按下“自动”按钮,起动机组。机组自动在怠速下运转暖机,待发动机油温、水温上升到45℃以上时,开始加速并达到正常运行状态。
1. Press the "auto" button to start the unit. The unit will automatically run and warm up at idle speed. When the engine oil temperature and water temperature rise to more than 45 ℃, it will start to accelerate and reach normal operation.
2、在运行中经常观察电气仪表(电流表、电压表、频率表和功率表等)以及发动机仪表[机油压力表(245~343KPa)、机油温度表(≤95℃)、水温表(≤95℃)和转速表(额定转速1500r/min)、排气温度(≤680℃)等)]的指示情况,其数值是否在正常范围之内。
2. During operation, always observe the indications of electrical instruments (ammeter, voltmeter, frequency meter, power meter, etc.) and engine instruments [oil pressure gauge (245~343kpa), oil temperature gauge (≤ 95 ℃), water temperature gauge (≤ 95 ℃), tachometer (rated speed 1500r/min), exhaust temperature (≤ 680 ℃)], and whether their values are within the normal range.
二、燃气发电机组千瓦运行中的注意事项
2、 Precautions in kW operation of gas-fired generator set
1、燃气发电机组千瓦每次起动的时间不得超过5s,若一次起动失败,可以间隔15s以后再次起动。若三次仍未成功,则应检查原因并排除故障以后再起动。
1. The starting time of the gas generator set per kW shall not exceed 5S. If one start fails, it can be started again after an interval of 15s. If it fails three times, check the cause and eliminate the fault before starting.
燃气发电机组
2、注意发动机的冷却水和机油的消耗状况,应及时添加。
2. Pay attention to the consumption of engine cooling water and oil, and add them in time.
3、随时注意各部位的过热、振动和异响等异常现象,并及时查明原因,排除故障。
3. Pay attention to abnormal phenomena such as overheating, vibration and abnormal noise at all parts at any time, and find out the causes in time to eliminate the faults.
4、注意发电机的工作状况,如发现有过热或不正常的火花现象,应及时停机检查和维修。
4. Pay attention to the working condition of the generator. In case of overheating or abnormal sparks, stop the machine in time for inspection and maintenance.
5、发电机周围环境应保持清洁,防水、油或沙尘等进入机组和发电机内部。不得用水冲刷发电机组。
5. The surrounding environment of the generator should be kept clean, and water, oil or sand and dust should enter the unit and generator. Do not flush the generator set with water.
6、严禁机组在仪表失灵或有其他故障时运行。
6. It is strictly forbidden to operate the unit in case of instrument failure or other faults.
要注意燃气发电机组千瓦使用过程中应作好运行记录,故障分析及处理记录才能让该设备更好的运行,更多内容的了解就来我们网站//www.gz-yanye.com看看吧。
It should be noted that the operation records should be made during the use of gas-fired generator units, and the fault analysis and treatment records can make the equipment operate better. For more information, please visit our website //www.gz-yanye.com Take a look.
新闻搜索
济南济柴环能燃气发电设备有限公司
  • 服务热线

    0531-62325028
    0531-69951266

燃气发电机组千瓦启动和运行注意事项

燃气发电机组千瓦起动和运行需要注意哪些事项呢?这不仅是为了保证机组的正常运行,更是为了让工作人员良好使用机组。燃气发电机组千瓦启动和运行注意事项小编做出介绍。
What matters need to be paid attention to when starting and running gas-fired generator units? This is not only to ensure the normal operation of the unit, but also to allow staff to make good use of the unit. The precautions for kW startup and operation of gas-fired generator units are introduced.
一、燃气发电机组千瓦启动的注意事项
1、 Precautions for kW startup of gas generator set
1、按下“自动”按钮,起动机组。机组自动在怠速下运转暖机,待发动机油温、水温上升到45℃以上时,开始加速并达到正常运行状态。
1. Press the "auto" button to start the unit. The unit will automatically run and warm up at idle speed. When the engine oil temperature and water temperature rise to more than 45 ℃, it will start to accelerate and reach normal operation.
2、在运行中经常观察电气仪表(电流表、电压表、频率表和功率表等)以及发动机仪表[机油压力表(245~343KPa)、机油温度表(≤95℃)、水温表(≤95℃)和转速表(额定转速1500r/min)、排气温度(≤680℃)等)]的指示情况,其数值是否在正常范围之内。
2. During operation, always observe the indications of electrical instruments (ammeter, voltmeter, frequency meter, power meter, etc.) and engine instruments [oil pressure gauge (245~343kpa), oil temperature gauge (≤ 95 ℃), water temperature gauge (≤ 95 ℃), tachometer (rated speed 1500r/min), exhaust temperature (≤ 680 ℃)], and whether their values are within the normal range.
二、燃气发电机组千瓦运行中的注意事项
2、 Precautions in kW operation of gas-fired generator set
1、燃气发电机组千瓦每次起动的时间不得超过5s,若一次起动失败,可以间隔15s以后再次起动。若三次仍未成功,则应检查原因并排除故障以后再起动。
1. The starting time of the gas generator set per kW shall not exceed 5S. If one start fails, it can be started again after an interval of 15s. If it fails three times, check the cause and eliminate the fault before starting.
燃气发电机组
2、注意发动机的冷却水和机油的消耗状况,应及时添加。
2. Pay attention to the consumption of engine cooling water and oil, and add them in time.
3、随时注意各部位的过热、振动和异响等异常现象,并及时查明原因,排除故障。
3. Pay attention to abnormal phenomena such as overheating, vibration and abnormal noise at all parts at any time, and find out the causes in time to eliminate the faults.
4、注意发电机的工作状况,如发现有过热或不正常的火花现象,应及时停机检查和维修。
4. Pay attention to the working condition of the generator. In case of overheating or abnormal sparks, stop the machine in time for inspection and maintenance.
5、发电机周围环境应保持清洁,防水、油或沙尘等进入机组和发电机内部。不得用水冲刷发电机组。
5. The surrounding environment of the generator should be kept clean, and water, oil or sand and dust should enter the unit and generator. Do not flush the generator set with water.
6、严禁机组在仪表失灵或有其他故障时运行。
6. It is strictly forbidden to operate the unit in case of instrument failure or other faults.
要注意燃气发电机组千瓦使用过程中应作好运行记录,故障分析及处理记录才能让该设备更好的运行,更多内容的了解就来我们网站//www.gz-yanye.com看看吧。
It should be noted that the operation records should be made during the use of gas-fired generator units, and the fault analysis and treatment records can make the equipment operate better. For more information, please visit our website //www.gz-yanye.com Take a look.
Baidu
map