不管是使用什么家电、开什么车或者是使用某一种工具的时候，我们都说要安全使用。对于焦化发电机组也是一样，想要安全操作使用发电机组需要注意三大事项。

No matter what household appliances we use, what cars we drive or what tools we use, we all say we should use them safely. The same is true for the coking generator set. If you want to operate the generator set safely, you need to pay attention to three matters.

启动前检查

Pre startup inspection

1、检查焦化发电机组机油油位是否在标示刻度线以内，不够加同型号机油至标示线以内。

1. Check whether the oil level of the coking generator set is within the marked mark, and if it is not enough, add oil of the same model to the mark.

2、检查冷却液是否在水箱盖以下6mm左右，不够加清水至上述位置。

2. Check whether the coolant is about 6mm below the water tank cover, and add water to the above position if not enough.

3、检查电解液液位是否在极板面上15mm左右，不够加蒸馏水至上述位置。

3. Check whether the electrolyte level is about 15mm above the plate surface, and add distilled water to the above position if not enough.

4、检查发电机周围，把有碍操作或运行的物品搬开，使得通风通畅。

4. Check the surroundings of the generator and remove the objects that hinder the operation or operation to make the ventilation unobstructed.

5、使得焦化发电机组总开关在OFF(关)状态。

5. Make the main switch of coking generator set in off state.

6、使得燃油箱油量在一半以上，燃油供油阀常开。

6. Make the fuel volume in the fuel tank more than half, and the fuel supply valve is normally open.

启动中

Starting

1、使得控制屏上各按钮已经复位，将速度操作手柄调到怠速位置

1. Make all buttons on the control screen have been reset, and adjust the speed operating handle to the idle position

2、把钥匙转到开的位置，按下启动按钮焦化发电机启动。

2. Turn the key to the on position and press the start button to start the coking generator.

3、将速度调节手柄慢慢上调直至电压为400V;频率、50赫芝时拧紧固定手柄螺母，发电机正常运行。

3. Slowly raise the speed adjusting handle until the voltage is 400V; Tighten the fixed handle nut when the frequency is 50 Hz, and the generator operates normally.

4、焦化发电机正常情况下，一次启动着车或三次启动着车，如果焦化发电机组三次不能启动着车，控制面板上的故障指示灯亮，此时应查明原因并排除故障再启动。

4. Under normal conditions, the coking generator starts and stops at one time or three times. If the coking generator unit cannot start and stops at three times, the fault indicator light on the control panel is on. At this time, find out the cause and eliminate the fault before starting.

5、启动着车后应检查有无噪音或震动，有无漏油，有无漏水，漏气现象，控制屏有无异常显示，在开机10~15秒内油压应达到正常范围（（35~60p.s.i）如有不正常情况应做出相应的整改，待正常后合上发电机总开关开始供电。

5. After starting the vehicle, check whether there is noise or vibration, whether there is oil leakage, whether there is water leakage, air leakage, and whether the control panel has abnormal display. The oil pressure should reach the normal range ((35~60p.s.i) within 10~15 seconds of starting the machine. If there is any abnormal condition, make corresponding rectification, and turn on the main switch of the generator to start power supply after it is normal.

停机

Shutdown

1、先扳下发电机总开关，让发电机空载运行5分钟，然后把调速手柄扳到怠速位置运行5分钟再扳到STOP的位置，焦化发电机停机。

1. First pull down the main switch of the generator and let the generator run without load for 5 minutes, then turn the speed control handle to the idle position for 5 minutes, and then turn it to the stop position, and the coking generator stops.

2、如有紧急情况需停车，可以不扳下发电机总开关直接将调速手柄扳到的位置焦化发电机停机。

2. If there is an emergency that requires shutdown, the coking generator can be shut down by directly turning the speed control handle to the position without pulling down the main switch of the generator.

以上就是今天为大家介绍的关于问题以及注意事项的全部内容，希望对大家能有所帮助，想要了解更多内容可以电话联系我们或者关注我们的网站//www.gz-yanye.com，我们的工作人员会及时与您取得联系。

The above is all about the problems and precautions introduced to you today. I hope it can help you. If you want to know more, you can contact us by phone or follow our website //www.gz-yanye.com , our staff will contact you in time.