With the reduction of energy reserves, exploring other forms of power generation technology becomes extremely important. Biogas generators have emerged in this context. So what are some things to pay attention to when the biogas generator is shut down

首先要做的是卸载：

The first thing to do is uninstall:

沼气发电机机组停机前，要先卸去负荷。

Before stopping the biogas generator unit, the load must be removed first.

怠速运转：额定转速下运转几分钟，初步冷却后，再将怠速/额定转换开关置于“怠速”位置，使机组怠速运转,使其水温和油温降下来。

Idle running: Run at rated speed for a few minutes, after initial cooling, place the idle/rated transfer switch in the "idle" position to idle the unit and lower its water and oil temperatures.

切断气源：当机组“水温”“油温”降低到60℃以下后，关闭手动

Cut off the air source: When the "water temperature" and "oil temperature" of the unit decrease to below 60 ℃, turn off the manual mode

燃气阀门。剩余的燃气可使机组继续运转12分钟，

Gas valve. The remaining gas can keep the unit running for 12 minutes,

燃气耗尽后，机组将自动停机。

After the gas is depleted, the unit will automatically shut down.

停机后，将控制屏面板上的钥匙关闭。

After shutdown, turn off the key on the control panel.

除发作飞车或工作场所呈现易

Except for the symptoms of speeding or workplace exposure

燃气等不测事故，正常状况下严禁带负荷停机。

Under normal conditions, it is strictly prohibited to shut down under load due to unexpected accidents such as gas.

若停机后需求长期封存，应将

If long-term storage is required after shutdown, it is necessary to

沼气发电机机组的冷却水和机油放净，将机组外表处置洁净，相关部位涂抹封存油，以免零件锈蚀。

Drain the cooling water and oil of the biogas generator unit, clean the exterior of the unit, and apply sealing oil to the relevant parts to prevent rusting of the parts.

紧急停机。正常运转的

Emergency stop. Normal operation

发电机组，未按正常停机步骤停机都属于紧急停机。主要有两种状况：

A generator set that fails to shut down according to normal shutdown steps is considered an emergency shutdown. There are two main situations:

发电机组因超速油压低等毛病缘由，自行报警停机。(2)在运用过程中，遇到危及人身及设备平安的紧急状况时，发电运转人员按下“紧急停车”按钮，人为机组停车。

The generator set automatically alarms and shuts down due to issues such as overspeed and low oil pressure. (2) In the process of operation, when encountering emergency situations that endanger personal and equipment safety, the power generation operator presses the "Emergency Stop" button to manually stop the unit.

紧急停机的处置措施：切断电源，用盘车工具人力盘转曲轴，同时用手动机油泵泵油，带机组水温油温降至60℃以下后，在停止检查处置。

Emergency shutdown measures: Cut off the power supply, manually turn the crankshaft with a turning tool, and use a manual oil pump to pump oil. After the water temperature and oil temperature of the unit drop to below 60 ℃, stop inspection and disposal.