不知道您对瓦斯发电机组的相关事项了解呢？实际上如果您对该设备有充足的了解，才能在后期的使用中顺利很多，减少不必要的问题出现。下面来讲讲机组对瓦斯的要求是怎样的。

I wonder if you know something about gas generator sets? In fact, if you have sufficient knowledge of the equipment, you can use it successfully in the later period and reduce unnecessary problems. Now let's talk about the requirements of the unit for gas.

机组对瓦斯的要求：

Requirements for gas of the unit:

在距离燃气机组燃气进气阀1m内

Within 1m from the gas inlet valve of the gas unit

1、瓦斯温度≤40℃；

1. Gas temperature ≤ 40 ℃;

2、瓦斯压力3～20kpa，压力变化率≤1kpa/min；

2. The gas pressure is 3~20kpa, and the pressure change rate is ≤ 1kpa/min;

3、H2S≤200mg/Nm3；

3、H2S≤200mg/Nm3；

4、对于CH4体积含量，高浓度瓦斯发电机组要求甲烷含量在25%以上，低浓度瓦斯发电机组要求甲烷含量在12%-25%可以正常启动。

4. For CH4 volume content, the high concentration gas generator set shall have a methane content of more than 25%, and the low concentration gas generator set shall have a methane content of 12% - 25% and can be started normally.

5、瓦斯中水分含量≤40g/Nm3

5. Moisture content in gas ≤ 40g/Nm3

6、杂质粒度≤5μm，杂质含量≤30mg/Nm3。

6. Impurity particle size ≤ 5 μ m. Impurity content ≤ 30mg/Nm3.

如果可燃气体中含硫及氨成分较高，不仅会严重腐蚀火花塞电极，而且会使机油中的酸值增加腐蚀机组内部零件，同时易于生成沉淀物，增加对发动机的磨损和腐蚀。

If the sulfur and ammonia components in the combustible gas are high, it will not only seriously corrode the spark plug electrode, but also increase the acid value in the engine oil to corrode the internal parts of the unit, and at the same time, it is easy to generate sediment, increasing the wear and corrosion of the engine.

机组电气指标：额定频率50HZ（60HZ可选），功率因数COSФ=0.8，额定电压400/230V，相线：三相四线制

Electrical indicators of the unit: rated frequency 50HZ (60HZ optional), power factor COS Ф= 0.8, rated voltage 400/230V, phase line: three-phase four wire system

此外要了解到发电机容量增大能降低单位容量成本，提高经济效益，而提高单机容量的更主要措施在于增加线负荷，但线负荷增加后绕组线圈的温度也随之升高，温度的增加对发电机的安全运行不利，因此瓦斯发电机组厂家认为要改善发电机的冷却条件，提高其散热强度，才能将发电机各个部位的温度控制在允许的范围以内，确保发电机安全、可靠地运行。

In addition, it should be understood that the increase of generator capacity can reduce the cost per unit capacity and improve the economic benefits. The main measure to increase the capacity of a single machine is to increase the line load. However, the temperature of the winding coil will also increase after the line load increases, which is unfavorable to the safe operation of the generator. Therefore, the manufacturer of gas generator sets believes that it is necessary to improve the cooling conditions of the generator and its heat dissipation intensity, Only then can the temperature of each part of the generator be controlled within the allowable range to ensure the safe and reliable operation of the generator.

机组对瓦斯的要求是怎样的？以上就是问题的相关解答了，若您需要了解机组其他资料、瓦斯发电机组报价或未展示的功率型号机组参数请联系我们//www.gz-yanye.com。

What are the requirements of the unit for gas? The above is the relevant answer to the question. If you need to know other information about the unit, gas generator unit quotation or unit parameters of the power model not shown, please contact us //www.gz-yanye.com 。